PC V installation question


Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #34501
    AvatarHouston husqvarna
    Participant

    Step 7 says to unplug the wire harness, Black 6 pin connector. Does this remain unplugged? If so, did anyone wrap the connections with electrical tape?

    Also, I cannot find TPS connector which in the instructions has an arrow with TPS in the same area as the crank position sensor

    #34502
    AvatarHouston husqvarna
    Participant

    I found the TPS with the cover over it. So I assume it says to disconnect the black six pin to gain easier access.

    #34503
    Avatarmikochu
    Participant

    Maybe this video can help?  https://youtu.be/w62-OJKDAPM

    #34505
    AvatarHouston husqvarna
    Participant

    Thank you, I got everything done and put it back together but the gear light is flashing and won’t go out of first. I loaded the software and made sure it was pre installed with the basic 701 Vitpilen stock exhaust. Any idea why it is doing this. I checked the connections and they are good.

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.